32mm Gauge Only
£150 (including P&P within the UK - for international shipping, contact us here) 
 
Released at the Llangollen Garden Railway Festival (June 2026), this kit is our take on the Vulcan-built, Spooner 0-4-0 KATHLEEN.
 
3D printed in filament, resin, and laser-cut acrylic.
Codenamed ELEANOR, it comes complete with a 3-6volt motor, nylon worm gears, 32mm printed wheels on 1/8" stainless steel axles, the necessary metal stock, nuts, screws & washers required to build the model in the photos.
Also included in the kit is a micro slide switch (with a corresponding hole in the tank top) and a selection of detail parts.
 
Access to a small "bench vice" is a MUST, to build this kit.
 
Building instructions are included with the kit.
 
Although not for beginners, the kit is reasonably easy to construct and requires basic tools, glue, paint and batteries to complete.
There is adequate room in the boiler for 4X AA batteries and your choice of RC unit.

Batteries, RC or any electronics (except micro switch) are not included in the kit.
 
Length (over buffers) - 210mm
Width - 86mm
Height (from railhead to chimney top) - 120mm
Wheelbase - 64mm